ANTEK AIR MAGNA 150, Инструкция по установке и обслуживанию

Страница: 31 / 53

31
If you wish to change the CURVE value:
1 Open the main menu INFORMATION by pressing the right- or the left-hand button once.
You will find the cursor at the sub-menu named OPERATION
2 Press the ”down” button to move the cursor to the sub-menu called HEAT CURVE.
3 Press the right-hand button once to open the menu. You will find the cursor at the parameter CURVE
4 Open the selected parameter by pressing the right-hand button once.
5 Increase or reduce the preset value using the ”up” or ”down” button. You will see from the diagram how the
gradient of CURVE changes.
Press the left-hand button three times to return to the main menu.
Adjustment of ROOM value
As mentioned above, you can also adjust heat curve and indoor temperature by changing the ROOM value. If you
use ROOM value to adjust the heat curve, the gradient does not change, i.e. it doesn’t become steeper or
flatter. Instead, the whole curve is moved by 3°C for every degree by which the ROOM value is changed.
The relation supply line temperature to outside air temperature will not be affected. The supply line temperature
will be increased or reduced by the same number of degrees all along the heat curve. See the following diagram.
Adjustment of the ROOM value should only be used for temporary changes of the indoor temperature. For long
term settings, the CURVE value should be adjusted as this is the most energy and cost efficient way to set the
indoor temperature.
For adjusting the heat curve, please refer to the chapter ”Adjustment of the CURVE value” on page 27.
Factory setting of ROOM value is 20°C.
Changing the ROOM value
If you wish to change the ROOM value:
1 Press the ”up” or ”down” button once to open the ROOM value for adjustment.
2 Increase or reduce the preset value using the ”up” or ”down” button so that the desired room temperature is
reached. Wait for 10 seconds or press the left-hand button once to return to the main menu.
CONTROL
Adjustments to be made regularly