ANTEK AIR MAGNA 150, Инструкция по установке и обслуживанию

Страница: 24 / 53

24
AIR MAGNA 150
GREEN ENERGY SYSTEMS
Menu Navigation
The right-hand button on the control panel is used to open the desired menu. The left-hand button is used to
return to the previous menu . The up and down buttons are used to navigate between the parameters of a menu.
A cursor (arrow) on the left-hand side of the display indicates which menu can be opened .
The up and down buttons are also used if you wish to increase or reduce a preset value.
Display of current operating mode
During normal operation, the following in formation will be displayed:
• Desired (preset) room temperature
• Whether there is a heating demand or not. If there is, there will also be symbols
telling which heat source is working– heat pump or auxiliary heater or both (see ”Symbols” on page 6).
• Which operating mode has been selected In addition to this, the following messages may be displayed:
• PHASE SEQUENCE :
The compressor in the heat pump is running in the wrong direction, which means that
heat is produced by the auxiliary heater only (see ”Alarm” on page 36).
• HIGH RETURN :
The temperature of the water returning from the radiators is too high so the heat pump will
not be allowed to produce heat. (see ”Alarm” on p. 36).
• START:
The heat pump is in the process of starting. There is a 30 second delay between start of brine system
pump and compressor.
• START_MIN :
The heat pump will start in the number of minutes indicated in the display.
CONTROLE
General Information