ANTEK AIR MAGNA 150, Инструкция по установке и обслуживанию

Страница: 11 / 53

11
Attention :
· When connection the pipe, a suitable pitching spanner must be used. If other spanner is used, it may
damage the joint due to inappropriate force.
· On connecting the pipe, one should ensure that the insulating material of the pipe be closely fitted to the
nuts at the joint.
· On connecting to the external unit, the pipe should be wrapped with sponge padding to prevent rain
water from flowing in.
· When bending the pipe, the radius cannot be too small and be about 150~160 mm.
3. Use Vacuum pump to remove the air from indoor unit and connection pipe.
4. Connect the electric cable as per circuit diagram, and bundle it with the
connecting pipe.
5. Take off the nuts in the mouths of high valve and low valve, turn the valves
core anticlockwise with hexagon panner till the valves are opened
completely. Recover and tighten the nuts.
6. Check leakage: check if there is leakage at each connection of the pipes or
nuts. If yes, remedial neasure must be taken, leakage is not permitted in any
case.
PIPE CONNECTIONS
How to connect the copper pipes
Piping Connection
1. Open the cover of the Outdoor unit.
2. Connect the pipe to the indoor unit and Outdoor unit.
· Wipe the quick connectors with clean cloth to prohibit dust and impurity entering the pipes.
· Align the centre of the pipe and fully screw in the angular nuts with Finger.
Spanner
Internal unit pipe
Angular nut
Pipe
Spanner
connecting pipe
thin pipe
end nut
Connector
low pressure valve
high pressure valve