Answer Drives GT3000, Руководство по аппаратному и программному обеспечению

Страница: 31 / 128

IMGT30017EN 19
3A. RECEIVING AND INSTALLATION
3A.1 Receiving, unloading, unpacking and inspecting the drive
All drives are fully inspected and tested prior to packing and shipment from the factory. Upon receipt, the equipment should be inspected for any
visible damage that may have occurred during transportation. The packing list should be carefully checked to ensure that all components, including
outline and schematic drawings of the equipment have been received. If any parts are damaged or missing, the purchaser should immediately file a
claim with the carrier, and then notify the factory.
After performing the incoming material inspection, the equipment should be promptly moved
1 to its final installation position or to a dry, weather-
protected and temperature-controlled area. Although each drive is well-protected against ambient and atmospheric agents, there are some
environmental conditions that can impair its operation and life. The drive is not weatherproof and must never be stored in outdoors.
The table 2A.3.3 provides the rated environmental conditions.
The operator should contact the manufacturer concerning special conditions that may exist at a particular site.
Fork lifts must be used to move units to their proper installation location. Units must be carefully lifted from the pallet into position by using a
mechanical lifting device such as a crane or fork lift.
When handling or lifting the units, be careful not to twist or jar the system. Protect all metal surfaces to keep them from becoming damaged.
NOTE: Keep any protective packaging until installation and start-up is completed.
3A.1.1 Lifting Frame I, II, III, IIIX, IIIL 3A.1.2 Lifting Frame IVN, VN, VIN
1
If the drive is shipped on a pallet, use an appropriately rated fork lift.