Ansmann Racing xBase 2.0 Deluxe, Инструкция по эксплуатации

Страница: 9 / 36

Digital Balance Charger xBase 2.0 Deluxe
9
5.4 NiMH/NiCd battery program
5.4.1 After check all the mode, to start the process press Enter/Start key for
more than 2 seconds.
Press “Mode/Esc” key to the screen on the left,then press “Enter/
Start” key to “Enter/Start” into the submenu. You can switch at the
same the level menu to select the mode by “Dec. </INC >” key.
Please refer to the detailed flow chart on the left. When you are
willing to alter the parameter value in the program, press
“Enter/Start” key to make it blink, then change the value with
“Dec. </INC >” key.
The value will be stored by pressing “Enter/Start” key once. Then
press “Enter/Start” key for more than 2 seconds to start the process.
Since the menu of NiMH are the same as NiCd, there is an example
of NiMH only.
“CHARGE“ mode: The default mode is “AUT”. In “AUT“ mode, you
need to set the upper limit of charge current to avoid from higher
feeding current that may damage the battery. Because some batteries
of low impedance and small capacity can lead to the higher charge
current by the processor at automatic charge mode. But in “Man“
mode, it will charge the battery with the charge current you set at the
display. Each mode can be switched by pressing start/enter key, when
the current field is blinking, press “Dec. </INC >” key for more than
1 second.
“DISCHARGE” mode:
The discharge current ranges from 0.1 A to
5.0 A and the final voltage ranges from 0.1 to 25.0 V. The operating
method is similar as Lithium battery. The final voltage of NiMH
battery is 1.0 V/cell, and the NiCd is 0.85 V/cell, please refer the
recommend by the battery of manufacturer.
“CYCLE” mode: This charger can perform 1 - 5 cycles of DCHG >
CHG or CHG > DCHG continually. You can select it for the new NI**
battery or the long-term placement NI** battery.
Please set up carefully, or it will
damage the battery!
To set the parameters please follow the previous charge/discharge
menu.
The screen displays the present state of process. To stop it press
“Mode/Esc.” key. Description:
①
the type of battery •
②
operating mode: CHG = charge •DSC = discharge •
DCHG > CHG or CHG > DCHG = the cycle mode
③
elapsed time
④
charge/discharge current of the battery
⑤
voltage of the battery pack
⑥
capacity of charge/discharge