Instruction Manual
6
5.3 Lithium batteries (Lilo/LiPo/LiFe)
program
Press “Mode/Esc” key to the screen on the left, then press “Enter/
Start” key to enter into the parameter setting menu. You can switch at
the same level menu by “Dec. </INC >” key.
Please refer to the detailed flow chart on the left. When you are
willing to alter the parameter value in the program, press “Enter/
Start” key to make it blink, then change the value with the key.
The value will be stored by pressing “Enter/Start” key once.
Then press “Enter/Start” key for more than 2 seconds to start the
process.
“AUTO charging“ this is for individual Lithium battery or some special
battery pack without balance port or cell count. The left side of the
first line shows the type of battery you select at the user setting. The
right side of the first line shows you the mode of charge. The value
on the left side of second line sets a charge current and the value on
the right side of second line sets the cells count of the battery. The
definition of the following screens are all the same. (To know how to
connect, plesase refer to picture B).
“Balance charging” this is for 2 - 6 cells of Lithium battery with
balance port, the battery pack being charged should have the
individual cell connect, and connect it to the individual port at the
right side of the charger with a suitable connection cable that fits with
your battery pack (see picture B). In this mode, the charging process
will be different from ordinary charging mode. The internal processor
of the charger will monitor and control the voltage of each cell of
the battery pack. This can improve the discharging performance of
the battery! EV charger use the optimised calculation to control the
tolerance in the range of ± 0.01 V!
“Fast Charging” select this mode to finish charging process earlier.
Principle: When the current down to 1/5 of the current you set
during the CV term, it will stop the process and eliminate the forcible
requirement of the balance precision. (Whether it is been connected
to the balance port), the charging capacity may be a bit smaller than
normal charging but the process time will be reduced.
“Storage mode” this is for charging or discharging Lithium battery
not to be used for the time being. In order to reduce the wastage, you
can select this mode to remain the power to 40% to store. The final
voltage are different from the type of the battery, LiIo: 3.75 V; LiPo:
3.85 V; LiFe: 3.3 V.
This is an intellective program. If the voltage of battery at its initial
stage is over the voltage level to storage, the program will start
to discharge,and if it is lower, the program will start to charge
automatically. In order to ensure each battery meets the demand,
the individual plug of the battery pack should be connected to the
individual port of the charger.
“Discharge mode” theoretically, Lithium battery do not need to
discharge, especially deep-discharge. This feature is to ensure the
power wastage of the Lithium battery over 90%, to avoid the over-
charge of the individual battery. You should connect the balance plug
of the battery to the charger, and the current may not exceed 1C.
Содержание xBase 2.0 Deluxe
Страница 13: ...Digital Balance Charger xBase 2 0 Deluxe 13...
