anko MT-600, Инструкция по эксплуатации

Страница: 32 / 36

Page 32 of 36
15.2 Operation Troubleshooting
Robot will not turn On
Check that the Battery is fully charged.
Ensure the Switch on the side of the Robot is in the “I” On
Position
Robot may have gone to sleep. Press the “On/Off” button to
wake Robot up.
Robot will not drive along
when wheels are turning
Carpet pile too long
Brushes may be caught. Remove obstacles
Excessively Noisy operation
Clean the Filters and empty the Dust Canister
Check for partial blockages and unblock.
Dirt / Debris not being picked
up.
Clean the Filters and empty the Dust Canister.
Check for blockages and unblock
Check that the Battery is fully charged.
Dirt / Debris particles too heavy or too large.
Carpet Pile too long
Robot Will not go Home to
the Charging Dock
Automatically
The power to the Charging Dock has been switched off or
unplugged. Ensure there is power to the charging dock at all
times.
The charging Dock may have been moved. Ensure the
Charging Dock is secure, against a wall and facing outward
with a 2 meter Radius clear environment around it.
There may be obstacles preventing the Robot from reaching
the charging dock. Remove all obstacles within a 2 meter
radius.
Robot gets Stuck
The robot may get stuck occasionally (i.e., in a corner) if it
does not sense the wall or object. If you leave the robot for a
few minutes, it will detect it is not moving and will get free by
itself. It may turn off, reverse, and will then continue to clean.
Alternatively, you may pick up the Robot and reposition it
yourself. Once repositioned, restart Robot.
Remote Control will not work
Batteries have been installed back to front. Ensure the + goes
to + and – goes to -
Batteries are flat. Replace with new batteries of same
specification.
Remote Control needs a direct line of sight to the robot.
The remote control needs to be pointed directly at the sensor
in front or rear of the Robot.