anko MT-600, Инструкция по эксплуатации

Страница: 21 / 36

Page 21 of 36
Pause
•
To Pause while cleaning, Press the button on the control panel on top
of the Robot or press the START/STOP button on the remote.
• Press either of these buttons again to resume cleaning.
Note : If the Robot is Paused for approximately 15 minutes, the Robot will
go to sleep. You will need to press either of these two buttons a second
time. The first press will wake the Robot, the second press will start the
Robot.
11.2 Manually Finishing a Cleaning Session
The Robot will automatically end the cleaning session when the battery is
too low.
Four beeps will sound, the On / Off button will flash Red, and the robot will
begin to manoeuvre back to the charging dock.
•
If you wish to end the cleaning process early, press the button on top
of the Robot, or the START/STOP button on the remote control to Pause
the cleaning.
•
To return the Robot to the charging dock to recharge, press the Home
button on the remote control and the Robot will begin to find the charging
dock.
Note : You may manually drive the robot back to near the charging dock by
using the direction arrows on the remote control so as to save time, or, you
may pick up the Robot and place it on the charging dock if it has run out of
battery before locating the charging dock, or to save time.
12 Advanced Cleaning
For a deeper and more precise clean, incorporate an advanced cleaning
feature to the cleaning session.
Before selecting an advanced cleaning method, ensure the Robot is Paused.