Anderson ROUND and SQUARE BALE WRAPPER HYBRID, Руководство оператора

Страница: 20 / 112

18
6 Beginning Continuous Bale Wrapping
Before Beginning
Check the level of oil in the hydraulic tank, as well as the level of fuel in the tank of the Honda
engine. Also check the Honda engine’s oil level using the gauge at the base behind the engine
(Figure 6.1).
Figure 6.1 Engine unit
If necessary, lubricate the machine well. Pay special attention to the long arms on which the
pusher supports slide inside the fenders.
Where to Wrap and Store Bales
First of all, choose a place where the continuous bale rows will be easily accessible in all
seasons or at the time of year when you will need to access your fodder. Be aware of possible
snowfall during the winter. The ground for storage should be flat, clean, and well-drained. If
necessary, mow the land or treat it with an herbicide such as Roundup to prevent rodent
infestation in winter and the serious damage they can cause to the plastic film. Additionally, the
ideal storage site should be on a slight slope to prevent rainwater from accumulating. If your
land is on a slight slope, it is best to begin your continuous bale row at the bottom and to climb
the slope by backing up the bale wrapper. Your continuous bale row will be more compressed
and will therefore contain less air.
Installing the 1
st
Plastic Film Roll
First, open the protective screen on the right side of the hoop. (The screen on the left side
always remains attached to the machine. In case of breakage, you can open it using the
appropriate tools.) Pull on the latch at the top left corner of the screen and slide it forward.
If one of the two film dispensers is not at a good height for your, manually turn the large hoop
upwards to bring the dispenser within reach.
To prevent the hoop from turning during installation, engage the hoop brake pedal, located to
the left of the drive wheel (Figure 6.2).
Figure 6.2 Brake pedal
Remove the pin from the front roll support, slide the support forward, and, if applicable,
remove the empty spool. Install the new roll so that the plastic film unwinds as indicated, push
the support back in place, and put back the pin (Figure 6.3).