Anderson ROUND and SQUARE BALE WRAPPER HYBRID, Руководство оператора

Страница: 52 / 112

50
Reinstall the 5 rollers.
13.2 Reassembly Instructions for Revolving Hoop
You have received your machine assembled in the factory according to the illustration below
(Figure 13.3) and you want to reinstall the hoop in normal position. Here are the steps to
follow:
1 – Go inside the frame of the machine underneath the hoop and take apart the 2 spikes by
unscrewing the hex screws on the inside of the 2 spike supports. You will need a ¾" hex key.
2 – Remaining in the same place, use a ¾" hex key to unscrew and remove the 2 bolts on the
2 sides of the chassis.
3 – Also remove the ½" bolts, which are located just above the hoop pivots on each side of the
machine.
4 – Raise the hoop to vertical position and place it correctly on the small tire of the drive wheel,
pushing the drive wheel downward if necessary.
5 – Go back inside the frame to reinstall the 2 bolts on each side of the chassis. Reinstall the
spikes. Screw back in the retaining hex screws. Also put the 2 ½" screws back in the holes
above the hoop pivots. Tighten securely.
6 – Raise the hoop’s 2 security screens, which are lying on the front of the machine. The left
security screen must be permanently bolted to the left post of the hoop. The right screen has a
handle that allows it to be opened as necessary to install the plastic film rolls. Fix the handle in
place.
Figure 13.3 Revolving hoop