Anderson ROUND and SQUARE BALE WRAPPER HYBRID, Руководство оператора

Страница: 40 / 112

38
11 Troubleshooting
Breakdown?!?
You machine is functioning poorly or not at all?!? Before calling a technician, examine your
machine and consult the table below to find a solution. If you are still not able to solve the
problem yourself, ask for help from the customer service department of your agricultural
dealer.
Troubleshooting Table
Problems Possible Causes Solutions
1. The engine does not
start.
The fuel valve is closed.
Open the fuel valve and start
again.
The gas tank is empty.
Put fuel in the tank and start
again.
The low engine oil sensor of the
Honda engine is activated.
Add oil to the engine and start
again.
The spark plug is clogged or
defective
Clean the spark plug or change it.
The engine is flooded because the
fuel valve was not closed during
transportation.
Remove the spark plug, dry it out,
dry out the cylinder by activating
the starter crank. Put back the
spark plug and start again.
Change the oil.
Too much oil in the oil pan. Adjust oil level.
2. The pusher does not
move forward.
The bale is not correctly placed on
the trigger or is not exerting enough
pressure on it.
Pick up the bale with the tractor
and rotate it a quarter turn around
its axis. Re-load bale.
If necessary, sufficiently widen the
bale guides.
The hydraulic oil level or pressure is
too low.
Check oil level. Also check for
leaks or holes. Repair if necessary.
Add hydraulic oil #32 (or TDH or
hydraulic transmission fluid) to the
tank.
The trigger is not properly adjusted.
Adjust the trigger. See adjustment
procedures.
3. The pusher goes
back to its starting
position without
finishing its trajectory.
The stopper is not in the right
position because it is not suited to
the bale format or it is not fully
pushed in.
Move the stopper to the right
place or check it.
The pusher does not reach the
stopper because the automatic
system spring is too tight.
The spring attachment must be
vertical or slightly inclined (up to
30°) clockwise. Adjust it.
Lack of oil pressure.
Check oil level. Check for leaks.
Adjust as needed.