AND Explosion Protected Weighing Indicator AD-4403-FP ST Series, Инструкция по эксплуатации

Страница: 111 / 112

F-2
Section Function Value Section Function Value
in F: Control I/O—Input AnF: Analog Output
in F-01 AnF-01 Output data
in F-02 AnF-02 Weight value at 4 mA output
in F-03 AnF-03
Weight value at 20 mA output
in F-04
CALF: Calibration
in F-05 CALF-01
Weighing unit
in F-06
Pin #1 to #9 of control signal terminal
inside the case
CALF-02
Decimal point position
outF: Control I/O—Output
CALF-03 Minimum division
outF-01 CALF-04
Capacity
outF-02 CALF-05
Zero range
outF-03 CALF-06 Zero Tracking Time
outF-04 CALF-07 Zero Tracking Width
outF-05 CALF-08 Motion detection time
outF-06
Pin #10, 11, 14, 15, 18, and 19 of
control signal terminal inside the case.
CALF-09 Motion detection width
SiF: Standard Serial Output
CALF-10
Tare and zero compensation at unstable
reading
SiF-01 Output data CALF-11 Tare at negative gross weight
SiF-02 Data transmitting mode CALF-12
Standard Serial Output: Output When
Weight value Is Overflowing or Unstable.
SiF-03 Baud rate (bps) CALF-13
RS-232C/-422/-485: Output When Weight
value Is Overflowing or Unstable.
SiF-04
Code number output
CALF-14
Weighing mode
rSF: OP-03(RS-422/485)OP-04 (RS-232C)
CALF-15 Preset tare
rSF-01
Output data
CALF-16
Distinguish between preset tare and tare
rSF -02
Data transmitting mode
CALF-17
Serial interface; Print preset tare value
with net weight (Si F-01=3, rsF-01=3)
rSF -03 Baud rate bps CALF-18
Push-zero and tare-clear function when
powered on and when the display is turned
on.
rSF -04 Parity CALF-19 Zero Input Voltage
rSF -05 Character bit length CALF-20 Span Input Voltage (Capacity to zero)
rSF -06 Stop bit length CALF 21 Weight against Span Input Voltage
rSF -07 Terminator
rSF -08
RS-422/485 switching
rSF -09
Address number
rSF -10
Code number output