Analogue Solutions NYBORG 12, Руководство пользователя

Страница: 38 / 40

Analogue Solutions | Nyborg | Manual
Internal Calibration of internal VCOs
Calibration of Nyborg is done at the factory and usually should not need to be changed.
Only attempt this yourself if you are fully confident you can do it. You may just end up
ruining the settings, and be aware calibration is something that we cannot help with
other the phone. There are no additional guides we can give by phone to help that are
not already printed here.
Trimmers
There are 3 trimmers per VCO, arranged in a vertical line accessed through small
holes in the top panel.
•
Top trimmer is Scale
•
Middle is Hi-Track
•
Bottom is Tune.
VCO1
1. Monitor VCO1.
2. Turn Fine and Course Tune controls to centre.
3. With MIDI connected, play C4.
4. Monitor the VCO1 output, and adjust bottom trimmer (tune) until the pitch of
VCO matches your reference of a 'C' note (reference using guitar tuner, digital
keyboard, etc.).
5. Play C3.
6. Adjust the top trimmer (Scale) until it matches your reference of a lower 'C' note.
7. Repeat steps 3 to 6 several times until all is in tune and a good octave is
obtained.
8. Play C6 and adjust the middle trimmer (Hi-Track) until it matches your
reference.
9. Repeat steps 3 through 8 until all is in tune.
VCO2
1. For VCO2 you repeat the above steps VCO1 can be used as a reference
instead of a tuner, using the zero-beat method.
Nyborg - Nov 2017
| Page ! 38