Analogue Solutions NYBORG 12, Руководство пользователя

Страница: 34 / 40

Analogue Solutions | Nyborg | Manual
Changing Mechanical Configuration
FITTING RACK EARS
Rack ears are optional.
To rack mount Nyborg, you will in fact need two of them, as the combined width makes
up one whole rack width. A single Nyborg cannot be rack mounted since they are half
rack width,
First the two Nyborgs but be screwed
together side by side. This involves
removing the front panel. See ‘Removing
Front Panel’ in the wood side panel fitting
instructions.
With the front panels removed carefully
screw the units together using 4 M4
screws. Use the four threaded holes that
are normally used for the rack ears/wood.
Optionally you could fit nylock nuts too, or
use thread-lock if you expect vibration to
work the screws loose (for example if they
will be transported a lot).
Next, replace the front panels.
Finally, screw the rack ears to the sides of
each Nyborg using M4 screws.
FITTING WOOD SIDES
Wood sides are optional.
They can be fitted to a single Nyborg, or,
two Nyborgs that have been bolted
together (see above, ‘Fitting Rack Ears’).
The wood is screwed from the inside. This
is so no screws are visible from the
outside which looks far smarter.
Unplug From Mains.
Remove 5 front panel screws.
Carefully unplug cable internal ribbon. There may be some hot glue securing it. Simply
pull that off with a pair of pliers.
Set aside Front panel.
Put the wood on the table.
Nyborg - Nov 2017
| Page ! 34