Analogue Solutions NYBORG 12, Руководство пользователя

Страница: 35 / 40

Analogue Solutions | Nyborg | Manual
Place the synth on its side on the wood.
Adjust position carefully. Typically set the front of the Nyborg back at least 5mm from
front edge of wood, or just place Nyborg centrally on the wood.
Screw Nyborg to the wood using self tap screws. It is not necessary to drill any pilot
holes.
Be careful not to strip the thread by over tightening.
Repeat for other side.
Then reassemble.
Ensure that you plug the cable back in correctly! The connector is keyed so it is hard,
but not impossible, to plug in incorrectly. Do not force it in.
CHANGING FROM VERTICAL TO HORIZONTAL ORIENTATION
As standard, Nyborg is a vertical machine much
like its big brother, the Telemark.
It is possible to rotate the front panel, and move
the MIDI/PSU PCB so that you can have the
synth flat, like a desk top device.
This involves some basic mechanics.
First, the front panel must be removed and
rotated 180 degrees. Removing the front panel
is described in ‘Fitting Wood Sides’ as outlined
above.
Next you need to remove the MIDI/PSU PCB.
This is one screw and 3 jack socket nuts.
Refit the MIDI/PSU PCB in the new position.
Remove 4 rubber feet and fit in new position.
Fit front panel in new position.
Whether rotating the front panel, fitting wood, or, screwing 2 units together, the task is
fairly simple, and basic engineering common sense is all that is needed. Doing these
won’t invalidate your warranty. But doing something stupid like snapping something,
slipping and mashing the PCB, etc will! And these will be very evident.
Nyborg - Nov 2017
| Page ! 35