NetLinx Programming of DXLink Transmitters and Receivers
95
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
Common DXLink Transmitter / Receiver SEND_COMMANDs
Common NetLinx SEND_COMMANDs for the DXLink Transmitters and Receivers are provided in the following table.
These commands can be sent to any port (the #3 Toggle
must
be set to ON).
Common NetLinx SEND-COMMANDs (Transmitters and Receivers)
Command
Description
?FWVERSION
Requests the firmware
version of the
TX or RX.
Syntax:
SEND_COMMAND <DEV>,"'?FWVERSION'"
Example:
SEND_COMMAND dvRX,"'?FWVERSION'"
Returns a COMMAND of the form:
FWVERSION <version-string>
LED-DIS
Disable all LEDs to the
right of the Program
port.
Syntax:
LED-DIS
Example:
SEND_COMMAND DEVICE_1,"'LED-DIS'"
Disables all LEDs to the right of the Program port on DEVICE_1.
Note:
This parameter does not get stored in non-volatile memory. LEDs are enabled by default
at each power-up.
LED-EN
Enable all LEDs to the
right of the Program
port (default).
Syntax:
LED-EN
Example:
SEND_COMMAND DEVICE_1,"'LED-EN'"
Enables all LEDs to the right of the Program port on DEVICE_1.
REBOOT
Reboot the module.
Syntax:
REBOOT
Example:
SEND_COMMAND DEVICE_1,"'REBOOT'"
Reboots DEVICE_1.
SET_NDX_DESC
Set Friendly name and
location for NDP.
Syntax:
SET_NDX_DESC-friendly name:location
Max of 25 characters for
friendly name
and max of 25 characters for
location
. If more than
25 characters are sent for either friendly name or location, they will be truncated to a max of
25 characters.
Neither the friendly name nor the location should contain a “:” character, as that is used as a
delimiter.
Note:
This command requires a reboot to enable new settings.
