Decoder Configuration Options
50
N3000 Series User Manual
Output Mode
Select the output resolution of the video to be
transmitted to the video output device (e.g., LCD). The
Scaler
check box must be enabled for this to be
applicable (see
Scaler
above).
Live/Local
Select live video or locally stored images for
transmission to the video output device (e.g., LCD).
When video is not available, it automatically goes into
local mode.
When video is not available, the most recently played
local playlist is displayed.
Mute
Enable to mute output audio.
Lineout Volume
This slider controls the output gain on the analog audio
output. By default, it controls both the left and right
lineout channels. Click the
Set Left/Right
link to control
channels individually.
Enable HDMI Audio
Set HDMI audio to be disabled, enabled, or selected
automatically based on the source.
ON
forces audio on at all times.
AUTO
reads the EDID
of the connected device to determine whether or not
to send audio.
Stream Settings
Refer to
Stream Settings
on page 51 for details on the
options available from this link.
Advanced Settings
Refer to
Advanced Settings
on page 52 for details on
the options available from this link.
Time Settings
Refer to
Time Settings
on page 54 for details on the
options available from this link.
RS232 Settings
Refer to
RS232 Settings
on page 54 for details on the
options available from this link.
Allow SVSI Multicast
Disable this option to prevent the port from outputting
multicast video traffic.
Particularly useful if you are connecting a non-SVSI
device to a port for network-based control.
Disable P1
Completely disables the P1 port for all traffic.
Once disabled, anything connected to the P1 port will
no longer be available on the network.
Cancel
Click to return all controls to the last saved
configuration.
Save
Click to accept changes made to these controls.
TABLE 16
Settings Page: Decoder Setup Section (Cont.)
Option
Description
Notes
