Encoder Configuration Options
30
N3000 Series User Manual
Advanced Settings
The section of the
Settings
page shown in
Figure 23
is displayed when you click the
Advanced Settings
link. Options are described
in
Table 4
.
FIG. 23
Advanced Settings
TABLE 4
Settings Page: Advanced Settings
Option
Description
Notes
Input Video Detect
Mode
Set to
Digital
to force the Encoder to detect only HDMI/
DVI sources. Set to
Analog
to force the Encoder to only
detect analog sources. Set to
Auto
for source auto-
detection.
Input Level Gain Left/
Right
Select a PRE-ENCODE cut in the audio signal.
This can help prevent distortion of the audio when the
source is providing audio that is too loud/clipping.
Setting does
not
affect digital audio.
Audio Gain
Slide right to provide a POST-ENCODE boost in the
audio signal (to both left and right channels).
This can help compensate when the source is
providing a weak audio signal. Does not affect digital
audio.
Audio Gain Left/Right
Slide right to provide a POST-ENCODE boost in the left
or right channel’s audio signal.
This can help compensate when the source is
providing a weak audio signal. Does not affect digital
audio.
Brightness
Use sliders to raise or lower RGB values of the Encoder
(POST-ENCODE).
Only affects analog video. Does not affect digital
video.
Component Sync
Window
Use this slider to configure the sync on green
sensitivity.
Used for computer video input to help with screen
flickering.
Input audio for
HostPlay
Enable to activate the input audio when the Live/Local
menu is set to one of the local images.
HostPlay for
Unsupported
Enable to cause the Encoder to use a custom image
whenever an unsupported video mode is supplied to it.
Gratuitous ARP
Enable the Encoder to send a periodic Address
Resolution Protocol (ARP) packet to the network.
