Amphenol Kaye CTR-40, Руководство пользователя, Страница: 24 / 84

13
4 Quick Start
4 Quick Start
This chapter gives a brief summary of the steps required to set up and operate
the bath. This should be used as a general overview and reference and not as a
substitute for the remainder of the manual. Please read Section 5, Installation,
through Section 7, General Operation, carefully before operating the bath.
4.1 Unpacking
Unpack the bath carefully and inspect it for any damage that may have oc-
curred during shipment. If there is shipping damage, notify the carrier immedi-
ately. Verify that all components are present:
•
CTR –40 Bath
•
Access Hole Cover
•
Manual
•
RS-232 Cable
•
Report of Test
•
Drain Valve
4.2 Set Up
Caution: The drain valve must be installed on the back of the bath before
attempting to fill the tank with fluid. See Section 5.3, page 17 for drain in-
stallation instructions.
Warning:
The instrument is equipped with a soft cutout (user settable firm-
ware) and a hard cutout (set at the factory). Check the flash point, boiling
point, or other fluid characteristic applicable to the circumstances of the
unit operation. Ensure that the soft cutout is adjusted to the fluid charac-
teristics of the application. As a guideline, the soft cutout should be set
10°C to 15°C below the flash point of the bath fluid. See Section 7.1, Heat
Transfer Fluid, for specific information on bath fluids and Section 8.10,
Cutout.
Set up of the bath requires careful unpacking and placement of the bath, install-
ing the drain valve, filling the bath with fluid, and connecting power. Consult
Section 5, Installation, for detailed instructions for proper installation of the
bath. Install the drain valve onto the pipe fitting at the back of the bath and