Ampetronic d series, Инструкция по установке и эксплуатации, Страница: 33 / 48

Ampetronic D Series Installation Handbook & User Guide Page 31
Reading Commands
These commands read back data from the Driver . They do not have an equals sign because the
commands are to read back data .
Command Response
mac MAC address of the unit
ip IP address in format XXX.XXX.XXX.XXX
dns DNS address in format XXX.XXX.XXX.XXX
gw Gateway address in format XXX.XXX.XXX.XXX
msk IP Mask if format XXX.XXX.XXX.XXX
disA
Displayed peak current on channel A (full rated current is 1) (Instantaneous
value).
disB
Displayed peak current on channel B (full rated current is 1) (Instantaneous
value).
comp Compression level in dB. (Instantaneous value).
pwri Input current from the transformer in Amps
lpra Returns loop A resistance as measured at the last power cycle .
lpla Returns loop A inductance as measured at the last power cycle .
lprb Returns loop B resistance as measured at the last power cycle .
lplb Returns loop B inductance as measured at the last power cycle .
temp Returns the heatsink temperature in Celsius
errs
Returns a decimal number with a bit set for each error that is present in the
amplifier.
1 – Amplifier too hot – performance derated
2 – Amplifier too hot – amp. Muted
4 – Transformer Overload – performance derated
8 – Transformer Overload – amp muted
16 – Loop A open circuit
32 – Loop B Open circuit
64 – Driver Internal Error
128 – Channel A clipping
256 – Channel B Clipping
512 – Amplifier Starting up
1024 – I2C2 Bus errors
Usage
Please note that the telnet commands are case sensitive and so the exact strings specified above
must be used to control the drivers .
Example 1: Set the current to -4 .3dB .
“cur=-4 .3 “
Example 2: Switch the mode of input channel 2 to “Mic with Phantom” .
“i2m=2 “
Example 3: Get the mac address of the driver .
“mac”