Ampetronic d series, Инструкция по установке и эксплуатации

Страница: 25 / 48

Ampetronic D Series Installation Handbook & User Guide Page 23
Driver ConfigTab
The driver config tab allow you to configure the Ethernet settings used by the driver. You can
also configure the driver to send an Email when a power cycle or error condition occurs or
regularly on a timed basis .
Finally you can use this tab to save the settings of the driver to an XML file on your device and
load a settings XML file into the driver to set it to a known configuration.
Driver Ethernet Configuration
This page allows the configuration of the driver network settings.
CAUTION: Incorrect settings may cause the driver to lose network connectivity. If a connection
cannot be obtained after changes, re-enable DHCP using the front panel controls.
Enter the new settings below: - when you press “Submit and Restart” the driver will restart to
implement the new network connection parameters.
MAC Address: 00:1E:C0:F8:70:DD
IP Address: 10.2.0.144
Gateway: 10.2.1.254
Subnet Mask: 255.255.254.0
Primary DNS: 10.2.0.11
Secondary DNS: 0.0.0.0
Driver Name: Departure Lounge
Logging Email: monitor@ampetronic.co
DHCP: On
Submit and Restart
Driver Status Email Configuration
These controls allow you to enable regaular status Emails from the driver.
These controls are effective immediately and do not require a restart.
Power Cycle: On
Compression
Current A
Current B
D14-2 (Departure Lounge)
Settings
Status
Driver Config