Amigo MicroModem, Руководство по установке

Страница: 13 / 37

13
& Ampersand Commands
&C0 Force DCD on
&C1 DCD follows remote carrier
&D0 DTR is assumed on
&D1 DTR drop causes modem back to command mode without disconnecting
&D2 DTR drop causes modem to hang up
&D3 DTR drop causes modem to be initialized; &Y determines which profile is loaded.
&F Load factory profile
&G0 Disable guard tone
&G1 Enable 550Hz guard tone
&G2 Enable 1800Hz guard tone on answering modem
&K0 Disable flow control
&K3 Enable RTS/CTS flow control
&K4 Enable XON/XOFF flow control
&K5 Enable transparent software flow control
&K6 Enable both RTS/CTS and XON/XOFF flow control
&P0 Selects 33%-67% make/break ratio at 10 pulses per second
&P1 Selects 33%-67% make/break ratio at 20 pulses per second
&P2 Selects 39%-61% make/break ratio at 10 pulses per second
& P3 Selects 39%-61% make/break ratio at 20 pulses per second
&S0 Force DSR on
&S1 DSR on at the start of handshaking and off after carrier loss
&T0 Terminate test
&T1 Start ALB test (not supported in MicroModem series)
&U0 Enable trellis coding
&U1 Disable trellis coding
&V0 Display active profile
&V1 Display stored profiles
&V2 Display stored telephone numbers
&W0 Save active profile to profile 0
&W1 Save active profile to profile 1
&Y0 Use profile 0 on power-up
&Y1 Use profile 1 on power-up
&Zn=m Save telephone number (up to 36 digits) into memory location n (0-9)