AMF S-4001 ISBH+I SM 30, Руководство по эксплуатации и ремонту, Страница: 21 / 90

1-9
Released: 09/2017
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
B - MACHINE INSTALLATION
S-4001 ISBH+I SM 30°
3. POWER AND AIR CONNECTION
1. The machine is equipped with a quick coupler 4 required with
connector for inner Ø of the tube 10. The connector for inner Ø
of the tube 8 is not supplied with the machine, a customer has
to order it. The manufacturer recommends to use connector
6
for who requires to connect the tube with connector NPT. If a
customer needs to use a shut off valve 1 , which allows fast
releasing of the air from the circuit, he must order it.
A variety of connectors
2
can be used separately or in
combination to adapt to the available input supply hose. It
depends on type of the tube which is used by a customer. These
connectors are not included in the accessories. A tubing clamp
3 is provided.
NOTE:
Parts 1 , 2 , 5 ,
6
are included in Extra Parts - see 3-63.
2. After air connection check the set air pressure on the dial of the regulator. It should be in range 0.5 - 0.6 MPa.
The green pointer 7 indicates the lowest working air pressure 0.5 MPa, which is set from the manufacturer on
the regulator
8
. If the air pressure is lower than 0.5 Mpa after connecting the machine to the power supply „Low
Pressure“ message appears on the control panel display. To adjust the working pressure, loosen the regulator
cap lock 10 and turn the regulator cap clockwise to increase the pressure. Push the regulator cap 10 down.
3. Power supply must be 208 to 230 volts 1 phase, 50 or 60 hertz. Receptacle plug must meet requirements of IEC
standard 364-4-41, its circuit breaker must be minimal 10A with characteristic C according to the EN 60947-2
(or 16A with characteristic B). No other devices must not be connected to the circuit breaker of the socker. The
hand wheel
12
must turn counter clockwise.
The machine is equipped with a filters which contain capacitors which generate an high frequency leakage
current. In order to prevent nuisance tripping, residual current protection device must be protected against
these high frequency currents: this is the case for industrial residual current device (example „S“ type).