AMF S-4000 BH Omron, Руководство по эксплуатации и ремонту, Страница: 57 / 78

S-4000 BH Omron
1-51 Released 05/2010
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
3 . C l a m p f e e t p r e s s u r e a d j u s t m e n t
The whole length of the clamp feet must hold the sewn
work with the same pressure.
a)
Push the clamp up/down button to close the clamp
feet
➌
.
b) To adjust the clamp feet to the correct position, loosen
the nut
➏
and turn the screw
➐
c) tighten the nut
➏
.
E - MACHINE ADJUSTMENTS
the same pressure
1 8 . A D J U S T M E N T O F T H E S T O P P I N G S E N S O R P O S I T I O N
Follow the below described steps to set the position of the sensor.
1. Put machine in the service mode (see E-3).
2. Turn the handwheel counter clockwise until the machine is in the position for sewing the second bar.
The stop disk finger
➊
must be perpendicular to the sensor
➋
.
3. Loosen the screws
➌
and move the sensor bracket
➍
to the right. Tighten the screws
➌
.
4. Loosen M3 screw
➎
and adjust the sensor position so that the stop disk finger
➊
is in the center of the
sensor mark
➏
. The red LED
➐
lights up on the sensor.
5. Tighten the M3 screw
➎
.
6. Return the machine head back to the working positon.
7. Push the F6 key on the control panel and switch the machine to the working mode.
8. Connect the air tubes with the indexer clamp feet. Open the air supply.
9. Start the machine and check the correct stopping of the machine. The needle bar must stop in
the home (upper) position.