S-4000 BH Omron
1-19
Released 05/2010
e-mail: [email protected]; [email protected]; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
D - MACHINE CONTROLS
1 . PROGRES FOR SEWING A BUTTONHOLE
1.
Bring the machine to the home position according to the section
C1
.
2.
Be certain that the machine is threaded correctly according to the section
C3
and insert the work
under the clamp feet.
3.
When the foot pedal
➌
is pressed to the first position, the work is clamped by the clamp feet.
(Releasing the foot pedal will rise the clamp feet).
N o t e :
It is possible to set the control so that both the clamping and the sew start are simultaneous,
consul the programming section for this information.
4.
When the foot pedal is pressed to its second position, the sewing is started. When a buttonhole is sewn
and the thread is trimmed, the machine goes to the home position and the clamp feet rise.
5.
When the clamp feet are up, it is possible to move the sewn work for sewing the second buttonhole.
6.
Machine can be stopped in any place of the cycle by pressing the Emergency Stop button
➍
which is
placed on the machine head. After releasing the Emergency Stop button, pressing the
button
and pressing the foot pedal, the machine finishes the buttonhole.
7.
If the foot pedal
➌
is pressed before finishing the buttonhole, the clamp feet will not rise and the
machine will again sew the buttonhole - possible to set in program.
8.
When the work is done, switch the machine off by the
➎
button, then stop the air supply by closing
valve which is behind the regulator.
➌
➎
➍
Содержание S-4000 BH Omron
Страница 4: ......