Released 06/2010
E-mail: [email protected]; [email protected]; website: www.amfreece.com
Phone: +420 582 309 286; Fax: +420 582 360 606
DECO 2000
1-6
A - INTRODUCTION
6. INSTRUCTIONS FOR THE SECURITY OF THE OPERATOR AND MAINTENANCE
When the machine is set to the working area, it is recommended to keep the minimal distance said in the draw-
ing.
D A N G E R ! D o not place the machine close to the steam irons because higher temperature than is said in
chapter Specifications can cause slight loss the quality of the waxed silk threads. Observe all directions said
bellow.
WA R N I N G !
-
Before machine connection to the power make sure, whether all safety covers are mounted.
-
If it is necessary to remove some safety covers, switch off the operating switch (circuit breaker)
and disconnect the machine by the fork of supply from the socket.
-
Do not connect the machine to the power if some cover is removed.
-
disconnection of connectors, when the machine is under electrical power is prohibited
-
Possible damage of electrical components and motors
-
W A R N I N G !
-
Remember the position of the Emergency stop button so that is possible use it from the arbitrary
position.
-
Make sure, whether supply of energy and its dimensioning and safeguarding allows permanent supply
of energy needed for dependable output of the machine.
-
Check if the electrical cables are not damaged, so that be touch with uncovered conductor, can not
occur any injury.
-
When the covers are damaged, repair or replace them immediately for the new ones.
-
Do not touch rotary shafts by hands.
-
In any circumstance, do not put hands to the needle space.
-
Before changing the needle, switch off the operating switch (circuit breaker).
-
Before cleaning or any maintenance work on the machine, disconnect the power supply by removing
the plug from the socket.