Amersham Pharmacia Biotech AKTA P-920, Руководство пользователя

Страница: 10 / 48

Pump P-920
User Manual 18-1125-54 Edition AB
4
2
Installation
2 Installation
2.1 Unpacking
Unpack the module and check the items against the supplied packing
list. Inspect the items for obvious damage that may have occurred
during transportation.
We recommend that all packing materials be retained if onward
transport of the module is expected.
2.2 General precautions
The module should be installed in a non-corrosive atmosphere.
The module should be located in a place of low temperature
variations, away from heat sources, draughts and direct sunlight.
The module may be operated at normal ambient temperatures in the
range +4 to +40 °C.
The module should be installed on a stable laboratory bench or in
an ÄKTAdesign chromatography system. To ensure correct
ventilation, a free space of 0.1 m is required behind and in front of
the module. Place the module directly on the bench. To ensure that
the ventilation inlet below the front is not blocked, do not place soft
material under the module.
2.3 Connecting electrical signal cables
The sockets for electrical signals are located on the rear panel.
Voltage
WARNING! For continued protection against
risk of fire, replace only woth fuse
of the specified type and current ratings
Frequency Power, max Fuse
100-200 V- 50-60 Hz 600 VA T 6,3 AL
Leakage current, max
3,5 mA
Mains
Mains output
UniNet 1
UniNet 2
Remote
Pressure
Analogue out 0-1 V
CAUTION! Read the following information carefully to ensure
that the module is installed correctly.
18-1125-54_ab.qxd 1998-10-22 12:49 Sida 4 (1,1)