American Megatrends Super Voyager PCI-II, Руководство пользователя

Страница: 31 / 67

Chapter 3 AMIBIOS and WINBIOS
28
Step 4 Install the Motherboard
The mounting hole pattern on the Super Voyager PCI-II 486 ISA motherboard is the same as the mounting hole pattern on any mini Baby AT
motherboard. Standoffs and mounting screws are not supplied with the motherboard. Install the motherboard as follows:
Step Action
1 Place the chassis for the motherboard on an anti-static mat.
Connect the chassis to ground to avoid static damage during
installation. Connect an alligator clip with a wire lead to
any unpainted part of the chassis. Ground the other end of
the lead at the same point as the mat and the wristband.
2 Rotate the chassis so that the front is to the right, and the
rear is to the left. The side facing you is where the
motherboard is mounted. The power supply is mounted at
the far end of the chassis.
3 Push four nylon standoffs from the solder side of the
motherboard in the holes provided for them. The standoffs
lock in place. Find the slots provided for the standoffs on
the chassis. Hold the motherboard, component-side up, with
the edge with the standoffs toward you and the edge with
the power supply connector away from you. The edge
connectors for the adapter cards should be to the left.
4 Carefully slide the motherboard into the chassis. Make
certain that the standoffs fit the slots provided for them. If
the standoffs are properly locked, the motherboard should
not slide. It should also rest level with the chassis. The far
edge should fit the slots in the plastic clips.
5 Place the two mounting screws in the holes provided for
them and tighten them. If necessary, shift the motherboard
slightly to align the mounting holes on the motherboard
with the holes on the chassis. See the graphic on page 11.