3.
To remove the damaged depth control disc or
depth control wheel
1
from the coulter,
press firmly against the depth control disc or
depth control wheel, move the lever
2
all the
way down and push it to the rear in the elongated
slot
3
until the depth control disc or depth
control wheel can be removed.
3
2
1
CMS-I-00004665
The removed unit consisting of depth control disc
or depth control wheel
4
and lever
2
can be
replaced as a whole or further disassembled. If only
the depth control disc or depth control wheel should
be replaced, the unit must be further disassembled as
described in the following.
4.
Remove the bolt
1
.
5.
Take the axle, ball bearing, locking rings and
locking washers
3
out of the worn depth control
disc or depth control wheel and insert them in the
new depth control disc or depth control wheel.
6.
Install the lever
2
with the bolt
1
on the new
depth control disc or depth control wheel
4
.
4
1
2
3
CMS-I-00004802
7.
To install the new depth control disc or depth
control wheel
5
on the coulter,
set the notch of the lever
4
on the bearing seat
1
of the cutting disc, press it firmly against the
depth control disc or depth control wheel and pull
the lever towards the front in the elongated slot
3
until the depth control disc or depth control
wheel completely engages.
8.
To adjust the placement depth,
pull on the lever for the depth control disc or
depth control wheel, move it up and engage it in
the desired hole
2
.
2
1
3
5
4
CMS-I-00004836
9 | Repairing the machine
Maintaining the machine
MG6545-EN-II | B.1 | 22.07.2021
93
