Amann Girrbach 178740-STM, Руководство пользователя

Страница: 37 / 68

37
M A C H I N E S P E C I F I C A T I O N S
E N
4 Machine Specifications
4.1 CoCr sintering furnace
4.1.1 Delivery Scope
_
CoCr sintering furnace
_
Heating rod (4
×
)
_
insulating stone, furnace ceiling
_
Exhaust air pipe
_
Ceramic tube
_
Floor plate
_
Insulating stone, front
_
Sintering compartment
_
Gas regulator/gauge
_
Connection hose for gas supply
_
Connection hose for compressed-air supply
_
Mains cable
_
Allen key
▷
After unpacking, check the machine for com-
pleteness and possible transport damages.
Please claim any transport damages immedi-
ately with your supplier.
4.1.2 Intended Use
The CoCr sintering furnace is used for sintering
milled CoCrMo units. The compact furnace is used
as a table-top model.
This high-temperature furnace has been specially
developed for sintering the Sintron material. Only
the Sintron materials, whose properties and sin-
tering temperatures are known, may be used. Any
other or further-going use, such as the processing
of other products than those intended for, as well
as the handling of hazardous substances or mate-
rials hazardous to one's health, does not apply as
under the intended use.
As to the materials being used in the furnace, it
must be known whether they are aggressive to or
even could lead to destruction of the insulation or
of the heating rods.
It is prohibited to remove safety devices, bypass
them or put them out of operation.
Unauthorised modifications/alterations of the
machine shall also void the warranty.
The set-up instructions and the safety regulations
must be followed, as otherwise the furnace is con-
sidered as not being used as intended for, and any
and all claims against the manufacturer shall
become void.
4.1.3 CE Declaration of Conformity
This product was designed and manufactured
based on careful selection of the harmonised
standards to be observed, as well as additional
technical specifications. It thus corresponds with
the state-of-the-art and ensures maximum safety.
In terms of design and performance, this product
complies with the European Directives and the
supplementary national requirements. Conform-
ity has been confirmed with the CE marking.
The product's Declaration of Conformity can be
viewed under the manufacturer's website.
EC Guidelines
2006/95/EC 2004/108/EC
Applied harmonised standards
DIN EN ISO 12100 DIN EN ISO 13732-1
DIN EN 61010-1 DIN EN 61000-6-1,
DIN EN 61000-6-3
Tab. 2