Amada MF-C300A-SF, Оригинальное руководство пользователя, Страница: 186 / 199

186
MF-C300A-SF/C500A-SF
Timing Chart
Repeated operation (EXTERNAL CONTROL)
The following diagram shows the lapse of time in the case where a signal is sent from
the PLC and schedule signal input, and then laser light is output from optical fiber.
*1 1s max. LD output preparation time
*2 Time required for the end signal to be output after a laser output
*3
Time required for outputting a signal to indicate whether the laser
energy is within the set upper limit value (HIGH) and lower limit value
(LOW) of monitor output
In *2 and *3, the output time is 20 ms but can be changed to 30 or 40 ms on the CONFIG screen.
LD ON Output
Schedule 1 Input *
Schedule 2 Input *
Schedule 4 Input *
Schedule 8 Input *
Schedule 16 Input *
Schedule 32 Input *
Schedule 64 Input *
Schedule 128 Input *
Ready Output
Laser Start Input *
(Laser light)
Laser Stop Input *
End Output
Monitor Normal/
Trouble Output
(*: Operation on the user side)
Laser beam is output repeatedly
according to Schedule 7 The laser repetition stops when
Laser Stop signal is input
Continuous output from optical fiber
*3
1ms or more
1s max . *1
The time set on the
CONFIG screen or more
The time set on the CONFIG screen *2