Amada HF2, Руководство по эксплуатации

Страница: 91 / 134

CHAPTER 7: SPECIAL FEATURES
2 KHZ INVERTER WEDLING POWER SUPPLY
990-057 7-13
NOTE: If SPC data has been collected using the optional Built-in Weld Sentry, a warning
message will follow the
ENTER
key asking if you want to continue. Press
ENTER
a second time
if you want to compete the reset process. When the reset process is complete, the bottom of the
screen will display the message
SCHEDULES/PROGRAMS ARE RESET
.
7 Press
MENU
to return to the
MAIN MENU
screen or press
RUN
to return to the Weld Graph
RUN
screen.
INSTALLATION
The Installation option provides 17 pages of written (no illustrations) instructions on how to set up the
HF2 Welding System. Press
ENTER
to select this option, followed by for each page. The best procedure
is to follow Chapter 2, General Set-up and Chapter 3, Welding Systems Set-up in this manual.
TRANSFORMER MODEL
The Power Supply cannot automatically detect what Transformer has been connected to its rear panel
OUTPUT Cable Connector
. If the correct Transformer is not selected before beginning to weld then, at
best, the weld current, voltage, or power actually delivered to the parts will not match the programmed
weld schedule settings. At worst, the Power Supply or Transformer may automatically shut down due to
thermal overloading.
1 Press
MENU
. The
MAIN MENU
screen
will appear.
2 Select
TRANSFORMER MODEL
. The
TRANSFORMER MODEL
screen will
appear.
3 Select
MULTIPLE HEADS: OFF
. If the
display reads
ON
, then press
CHNG
until
OFF
is displayed.
4
Select
HEAD 1 : X3/4000-230
. IT-X3/230
is the default Transformer Model
number. Press
CHNG
until the correct
Transformer Model that you have
purchased appears.