Amada HF2, Руководство по эксплуатации

Страница: 79 / 134

2 KHZ INVERTER WEDLING POWER SUPPLY
990-057 7-1
CHAPTER 7
SPECIAL FEATURES
System Options
The Power Supply has ten different system
options available. Most of these user
programmable options allow you to modify how
an external input such as a Foot Switch interfaces
with the Power Supply. Other options allow the
operator to decide what type of Weld Head will
be used and how the Weld Head will interface
with the Power Supply.
Figure 7-1. Main Menu Screen
OPTIONS 1 (Figure 7-1)
1 Press
MENU
. The
MAIN MENU
screen
will appear.
Select
OPTIONS
. The last
OPTIONS
screen displayed will appear. Press the
key until the
OPTIONS 1
screen is
displayed. Five items appear as shown
in Figure 7-2.
Figure 7-2. OPTIONS 1 Screen
POWER UP SCHEDULE (Figure 7-2)
This option determines which weld schedule will be used when the Power Supply is switched ON: (a)
Schedule Number 0 – 127 or (b) the weld schedule which was selected just before the power was switched
OFF.
1 Press
CHNG
to select 000 and then key in a weld schedule number that you want the Power
Supply to display on power up.
2 Press . to change a specific weld schedule to
LAST
.
END CYCLE BUZZER (Figure 7-2)
3 This option is normally used with Manually Actuated Weld Heads. ON means that an audible
signal will be given at the end of each weld process as a signal to the operator to release the Foot
Pedal. Press
CHNG
to select
ON
or
OFF
. NOTE: The selection
END CYCLE BUZZER
on the
OPTIONS 1
screen will read
END WELD BUZZER
if you are using the
BASIC WELD
function.
KEY CLICK (Figure 7-2)
This option provides a "click" sound when any front panel key is pressed. Press
CHNG
to select
ON
or
OFF
.