FIXING SIDE PANELS
Fixing the remaining side panels Alton Amateur from Summer Greenhouses
see
see
fig 8
fig 5
fig 7
fig 6
see
fig 9
see
fig 8
Repeat the same procedures for fitting the
remaining side sections in place. Where side
sections meet each other use the shorter 2
3
/
8
” /
60mm bolts and fix with a washer and nut, as
shown in fig 7. Remember to ensure the bolt head
is inside the channel of the lift up vent.
Continue to prop the sides as you progress.
fig 7
Remember to fix the panels to the cills as before
with a 2”/ 50mm countersunk screw though each
pre- drilled hole, as shown in fig 8.
Fix the plastic tongue in the slot between the side
panels. This may be done from either the top or
bottom. See fig 9. Bend the plastic tongue over
on itself when you push the end into the slot. This
will prevent it from sliding back out. You may find it
easier to accomplish this by gripping the folded
end with a pair of pliers.
fig 9
Note: OPTION
If required, it is at this point that the partition
needs to be positioned. Please refer to page 12 for
full instructions.
page 9
Phone Summer Greenhouses free 7 days a week on 0800 9777 828 or visit www.SummerGreenhouses.com
