SINGLE DOOR
Fixing the Single Door Alton Amateur from Summer Greenhouses
see fig 2
see fig 3/4
fig 2
fig 1
To help you get the correct clearance under the
door it can help to lay the timber door stop
(slamming strip) on level ground at the door
entrance so the under side is level with the
bottom of the kerbs. If you then stand the door
on the strip this will give you clearance of about
3
/
8
” / 10mm beneath the door.
Check with a spirit level that the door is vertical
and then hold the metal top door track in position
and mark its location on the frame.
Take the door away and fit the metal top door
track. Ensure the right hand end lines up with the
outside edge of the door post and fix with 4 off
1”/ 25mm countersunk screws as shown in fig 2.
Assemble the door pelmet with 6 off 1”/25mm)
nails as shown in fig 3 being careful not to split
the timber. Secure the pelmet to the metal top
door track using 4 off
1
/
2
” / 12mm countersunk
screws as in fig 4.
Slide the door into position on the door track.
page 18
fig 3
fig 4
Phone Summer Greenhouses free 7 days a week on 0800 9777 828 or visit www.SummerGreenhouses.com