Altigen AltiWare OE 4.6, Руководство администратора

Страница: 267 / 518

Extension and Group Configuration
AltiWare OE System Installation & Administration Manual 8-19
8
.E
x
te
n
s
io
n
&
G
ro
u
p
Conf
ig
ur
a
tion
Configure the following hardware extension-specific features:
Caution: If the Receiver Gain or the Transmission Attenuation
setting is too high, the result will be distortion in voice
quality.
Phone Display Options
For analog and IP phones, the administrator can select what information is
to be displayed. Depending on the number of display lines on the LCD, the
phone can be set up to show two lines of specific caller information on the
display.
In the Phone Display field, use the Number Line and Name Line drop-
down lists to select the caller information to display:
• Caller Number
• Caller Name
• DNIS Number
• DNIS Name
• IVR Data
Parameter Description
Message Waiting
Signal Type FSK or None.
Caller ID Signal
Format SDMF, MDMF, or None.
Line Disconnect
Signal The loop break desired for answering
supervision, either 200 or 600 ms.
Note: If the extension uses a 390 phone with
Intercom service, set this to 750 ms.
Ringing Frequency Select the frequency in Hz that is necessary for
the equipment attached to this line.
Receiver Gain/
Transmission
Attenuation Incoming and outgoing volume for every
extension. Unlike the Quantum board, these
slide settings have positive and negative values.
Both defaults are 0 decibels.