Altigen AltiWare OE 4.6, Руководство администратора

Страница: 196 / 518

Configuring the Triton VoIP Board
6-14 AltiWare OE System Installation & Administration Manual
Figure 1 shows a typical home network layout with DSL/cable modem with
an IP phone and PCs. A router that supports H.323 over NAT is required
between the DSL/Cable Modem and IP phone and PCs, if the DSL/Cable
Modem does not support H.323 over NAT. If this router provides multiple
10/100 BaseT ports for devices behind NAT, the IP phone and PCs plug
into these ports. Otherwise, a hub or switch is necessary to connect this
router, IP phone and PCs.
In the case where the DSL/Cable Modem supports H.323 over NAT, the
router and the DSL/Cable Modem can be converged into a single system.
Please refer to “Setup” on page 6-15 for detailed configuration of IP phones
and routers.
Public Network Configuration (AltiWare with Public IP
Address)
Figure 7. AltiWare with Public IP Address
Figure 2 shows a network layout in which AltiWare is installed and running
on a host with public IP address 169.254.101.2. The local IP phones, IP
Phone 1 and IP Phone 2, use public IP addresses 169.254.101.100 and
169.254.101.101, respectively. There are two remote IP phones. IP Phone