Altec DRM 12, Руководство пользователя

Страница: 30 / 143

Section 4 — Before You Operate… • 25
Caution
Injury can result from improper handling of materi-
als. Do not attempt to lift material that is too heavy
to be lifted safely.
Be sure to cut all trees, tree limbs, and brush into lengths
that can be safely handled by the operating personnel
available.
Notice
Know the limitations of the chipper. Never attempt
to feed material too large for the chipper. Always
precut large crotches to ensure adequate clearance
through the transition area.
When preparing large material for feeding the chipper,
properly trimming the crotches will greatly reduce the
amount of downtime clearing transition/feed roller jammed
materials. Either clear cut the limbs off the largest material
to be chipped, or courtesy cut partially though the limbs
which will allow the smaller limbs to fold back during the
chipping operation.
Consider the total width when utilizing a courtesy cut.
The total width will include the diameter and radius of
the bend of limbs as they fold back during the feeding
process. Exceeding the opening size can result in lodging
of material in the transition area.
Figure 4.3 — Type of Cut
Starting the Engine
Danger
Death or serious injury will result from careless or
improper use of the unit. Do not operate the unit
without proper training.
You must read and understand the entire Operator’s
Manual and all safety decals/placards prior to operation
of the chipper.
Warning
Death or serious injury or property damage can result
from airborne objects. Make sure all guards are in
place before operating the chipper.
Never start the engine with the drum hood open.
Before starting the engine, check the infeed chute to
make sure it is clear of any foreign objects and that the
discharge chute is directed away from personnel.
Notice
Disengage the clutch and place the feed control bar
in the center neutral position. Never force the clutch
lever. You can damage the linkage. Make sure the
clutch handle has adequate free play before operat-
ing.
Never engage the starter for more than 30 seconds con-
tinuously. Allow two minutes between attempts to start.
This will allow the starter to cool down.
Notice
Engine life will be significantly increased by allowing
the engine to operate at a fast idle for 7 to 10 minutes
before engaging the clutch.
The greatest amount of wear to an engine occurs when it
is first started and is cold. The lubricating oil has drained
back into the oil pan and does not flow freely to the entire
engine when first started. To achieve the greatest life
from your engine, do not operate at high speed or heavy
loads until the engine has warmed up.
Refer to EOM supplied with the chipper for specific start-
up, operational, and maintenance instructions.
Engaging/Disengaging the Cutter Head
Engaging
Warning
Death or serious injury can result from airborne
materials. Make sure no personnel are in the path of
material that might be discharged from chipper.
Caution
Injury can result from potential hazards of operating
and being in the operational area of this unit. Wear
appropriate safety equipment.
Clear Cut Courtesy Cut