Altec DRM 12, Руководство пользователя

Страница: 46 / 143

Section 7 — Maintenance • 41
Notice
Change the oil if the sample has any of the charac-
teristics listed in Figure 7.1.
If making a visual inspection, compare the sample of oil
to a sample of new oil of the same type. Also, compare
it to previous samples taken from the same unit. Look for
the signs of oil deterioration listed in Figure 7.1.
There are fluid contamination detector kits available
which allow for rapid, on-the-spot analysis of the hydraulic
system’s condition. Contact your Altec representative for
further information.
Oxidation produces varnishes that bake onto hot sur -
faces. Oxidation products are acidic and tend to attack
metal surfaces. This can damage pumps, motors, and
valves. High operating temperatures will increase the
rate of oxidation of the oil. The presence of water or air
in hydraulic oil also causes oxidation.
The presence of water may cause rust and corrosion. If
laboratory analysis or visual inspection indicate that the
oil is deteriorating prematurely, determine the cause of
the problem and correct it.
Changing Oil and Flushing the System
A properly maintained filtration system greatly extends
the useful life of the hydraulic oil. However, the oil will
eventually need to be replaced due to contaminants that
form during normal operation of the unit.
It is impossible to recommend an exact time interval for
oil changes due to varying conditions of unit use. Use
the following guidelines to determine when the hydraulic
oil should be changed.
• Change the oil as recommended by the checklists
in the Appendix.
• If a hydraulic component fails and contaminates the
system with metallic particles, change the component
and the oil immediately.
• In climates with a wide variation in operating tempera -
tures between summer and winter months, change
to the appropriate weight oil each spring and fall.
Replace the return line filter cartridge and filler breather
cap every time the hydraulic oil is changed. Also, clean
or replace the suction filter.
A significant quantity of oil remains in the hydraulic system
when the reservoir is drained. Flush the system when the
oil is changed. This is especially important if the system
is heavily contaminated with metal particles.
If the oil is contaminated with water, it may not be neces-
sary to change the oil and flush the system. Follow the
instructions under Water Removal in this section.
The following equipment and supplies are necessary to
properly flush the hydraulic system.
• Approximately 13 gallons (49 l) of proper hydraulic
oil
• Three return line filter cartridges
• Clean, lint-free rags
• Breather (if component has not been replaced
within one year)
Caution
Spilled hydraulic oil creates slick surfaces and can
cause personnel to slip and/or fall. Keep the unit and
work areas clean.
Use the following procedure to flush the hydraulic sys -
tem.
1. If the oil is being changed because of contamination
due to hydraulic component failure, proceed to step
2. Otherwise, operate the unit to circulate the oil and
warm it to operating temperature. This will allow many
of the impurities to drain off in suspension.
2. Drain the oil reservoir completely.
Figure 7.1 — Hydraulic Oil Conditions
Condition Possible Cause
Dark color Oxidation; contamination
Cloudiness or milky appearance Presence of water or wax
Rancid or burned odor Oxidation
Increase in viscosity Oxidation; addition of improper fluids; presence of water
Decrease in viscosity Addition of improper fluids; additive deterioration
Separation of water or other fluids from the oil Presence of water; addition of improper fluids
Foreign particles or other visible contamination Contamination; emulsion of water with oil additives