Altec ATP3000, Руководство пользователя

Страница: 36 / 63

35
+31(0)78 - 615 20 33
info@altec.nl
www.altec.nl +32(0)2 - 270 34 88
info@altec.be
www.altec.be
NL BE
Direction The direction setting value is either 1 or 0. Use this item to setup the
printout direction.
Direction 0 Direction 1
0
Print mode This item is used to set the print mode. There are 6 modes as below:
Printer mode Description
None Next label top of form is aligned to the print head
burn line location (tear-off mode).
Batch mode Once image is printed completely, label gap/black
mark will be fed to the tear plate location to tear
away.
Peeler mode Enable the label peel off mode.
Cutter mode Enable the label cutter mode.
Cutter batch Cut the label once at the end of the printing job.
Rewinder mode Enable the label rewinder mode.
Batch mode
Offset This item is used to fine tune media stop location. Available setting value
range is from -999 dots to 999 dots. 0 dot
Shift X This item is used to fine tune print position. Available setting value range
is from -999 dots to 999 dots. 0 dot
Shift Y 0 dot
Reference X This item is used to set the origin of printer coordinate system
horizontally and vertically. Available setting range is from 0 dot to 999
dots. 0 dot
Reference Y 0 dot
Code page Use this item to set the code page of international character set. 850
Country Use this option to set the country code. Available setting value range is
from 1 to 358. 001
Note: If printing from enclosed software/driver, the software/driver will send out the commands, which will
overwrite the settings set from the panel.
Direction
Dire ctio n
FEED