65
Reference
If this message appears
Various messages are displayed on the monitor screen during operation. In addition to the
messages telling you the current status or providing guidance for the next operation, there are
also the following error messages. If one of these error messages is displayed, carefully follow
the instructions in the solution column.
Message
Please insert map CD ROM.
CD ROM unreadable. Please
check CD ROM.
CD ROM being checked.
Do not operate while driving.
Stop the vehicle, then use this
operation.
Home is not registered.
Register it before using this
function.
Not registered.
Register before using this
function.
Specify the destination before
using this function.
Too many registrations.
Erase some, then use this
function.
Roads cannot be found in that
area.
Specify near a major road.
No route could be found.
Move to another location, then
try this operation again.
No route could be found.
The route from before the
search is displayed.
Use after setting the waypoint.
Cause
•
The disc has been removed.
•
There was no disc in the system when
the power was switched on.
•
A disc that the system cannot read has
been loaded.
•
The disc is dirty or upside down.
•
The disc cannot be read because of
condensation.
•
A disc was just inserted
•
Vibration or the like made it impossible
to read the disc.
•
The
MENU
button was pressed while
the vehicle was running.
•
A menu selection operation was carried
out while the vehicle was running.
•
An attempt was made to search the
map from home with no home
registered.
•
An attempt was made to search the
map from a memory point with no
memory point registered.
•
An attempt was made to search the
map from the Departure point with no
destination registered.
•
All-route display, all-route search, or
route deletion was attempted with no
destination registered.
•
An attempt was made to indicate a
waypoint with no destination
registered.
•
An attempt was made to register more
than 99 points in memory.
•
When the destination or waypoint was
specified, there was no road in the
area, so no route could be found.
•
No route could be found, for example
due to traffic situations.
•
When the
ROUTE
button was pressed
during a route search to switch
between motorway selection/ordinary
road selection for route searching, for
some reason, no route could be found.
•
An attempt was made to erase a
waypoint even though no waypoint is
set.
Solution
Insert the disc (sold separately).
Insert the map disc (sold separately).
Take out the disc, check if it was upside
down, clean it if necessary, then re-
insert it.
Take out the disc, allow it to dry for a
while, then re-insert it.
When the disc check is complete, the
following screen is displayed
automatically.
Move the vehicle to a safe location, stop,
and engage the parking brake, then
carry out this operation.
Register your home, then search the
map.
Register a memory point, then search
the map.
Specify the destination, then carry out
the search.
Specify the destination, then carry out
the operation.
Specify the destination, then specify the
waypoint.
Erase unnecessary points, then register.
Focus on a nearby major road, then
specify the destination or waypoint
again.
Move to another location, then press the
ROUTE
button to start the route search
again.
Either drive in your original mode
(motorway selection/ordinary road
selection) or move to another location,
then press the
ROUTE
button to resume
the route search.
This message simply announces that no
waypoint is set. The message goes out
soon.
