Alpha-InnoTec LW 161H/V, Руководство по эксплуатации

Страница: 21 / 48

21
Subject to change without notice | 83061600bUK | ait-deutschland GmbH
25 Installing the control unit
There are 4 openings each at different heights in the
front panel of the unit for fastening the control unit:
1 four upper openings
2 four lower openings
There are 4 hooks at the rear of the control unit, which
are used to hook the control unit onto the front panel
of the unit:
1. Hook the control unit's hooks into the openings of
the front panel (either in the upper or lower open-
ings).
Example: Control unit in upper openings
2. Press the hooked in control unit downwards until it
latches into position.
3. Push the control cable of the heating and heat
pump controller into the right socket on the un-
derside of the control unit.
NOTE
A connection to a computer or a network can
be made via the left socket on the underside
of the control unit, in order to enable the
heating and heat pump controller to be
controlled remotely from there. This requires
a shielded network cable (category 6) to have
been laid through the unit during the electrical
connection work.

Operating manual for the heating and heat pump
controller, part 2, “Web server” section
If this network cable is available, insert the
network cable's RJ45 connector into the left
socket of the control unit.
NOTE
The network cable can be exchanged at any
time. In order to be able to connect it, the
screen must first be removed.