Alpha-InnoTec LW 161H/V, Руководство по эксплуатации

Страница: 15 / 48

15
Subject to change without notice | 83061600bUK | ait-deutschland GmbH
Fixing the air ducts in the wall penetration
1. Pull the rolling O-ring joint supplied over one end
of an air duct.
2. Push the air duct into the wall penetration with this
end first.
1 Wall penetration
2 Air duct
3 Rolling O-ring joint
4 Waterstop tape (do not attach until after the
unit connections have been fixed)
NOTE
After the other end of the air duct has also
been fixed onto the heat pump, seal off the
opening that still exists between the wall
penetration and the air duct by attaching the
waterstop tape supplied.
Fixing the air ducts onto the heat pump
1. Clip on the mounting strip and use special screws
to fix onto the places provided for this purpose on
the air duct for the air inlet side.
2. Glue the connection frame supplied onto the edge
of the air duct.
3. Position the air duct on the respective air opening
of the air inlet side.
4. At the air inlet side of the heat pump, hook 4 of the
tension springs supplied in the holes provided for
this purpose.
5. Hook the tension springs into the mounting strip
screwed onto the air duct.
6. Fix the protective caps above the mounting strip.
7. Repeat procedure 1 – 6 at the air outlet side.
NOTE
Do not forget:
After the air ducts have been fixed onto the
heat pump, seal off the opening that still exists
between the wall penetration and the air duct
by attaching the waterstop tape supplied.
NOTE
Use suitable means to fix the air ducts to the
ceiling.