Alpha-InnoTec LW 161H/V, Руководство по эксплуатации

Страница: 14 / 48

14
Subject to change without notice | 83061600bUK | ait-deutschland GmbH
or subsequently (by foaming in place in the
masonry):
1 Finished external façade
NOTE
Wall penetrations are used for fixing in the
masonry opening, to avoid cold bridges with
the masonry, and to install weather and rain
louvres and wire mesh.
Assembly and installation of the air ducts
1. Take the elements for assembling the air ducts
from the relevant box.
2. The air ducts are assembled by pushing them to-
gether as is described in the “Assembly and in-
stallation of the wall penetration(s)” section, 2 – 5.
IMPORTANT
The height difference between the vertical
centre of the air duct connections on the
unit and the top edge of the air inlet / air out-
let on the building must not exceed 2 m.
4. Turn the already pushed together parts through
90° and push on the last element at the bottom.
5. Turn the already pushed together parts through
90° again and make the last connection.
6. Use the particleboards supplied to stabilise the
wall penetration on the inside.
7. Insert the wall penetration in the masonry from
the outside of the building . This can either be
done during the building shell construction phase
(by bricking around the penetration).
NOTE
Install wall penetrations 1 cm above the
finished external façade.
1 Outside of the building masonry
2 Inert the wall penetration in the masonry (1
cm above the finished external façade)