Alpha-InnoTec Luxtronik Series, Руководство по эксплуатации

Страница: 29 / 48

29
We reserve the right to make technical changes | 83055600dUK – Translation of the original instruction manual (HMD 2) | ait-deutschland GmbH
Pump flow
NOTE
Changing settings requires installer or customer service ac-
cess.
Pump flow ZUP Pump flow additional circulation pump
Second heat gen. 1 Selected additional heat generator 1
(ZWE 1)
Type
No no ZWE 1 connected, system operates
monovalently
El.Rod Electric heating element with bivalent
level control for heating element ( not
released during the El. sup. blockade )
Boiler Heating boiler with bivalent level
control for the boiler ( in bivalent level 3
is on continuously, until switched back to
bivalent level 2 )
Thermal Water heater with bivalent level control
for water heater ( control behaviour is
analogous to that of a heating element;
however, is also active during El. sup.
blockade )
Function
No without function
Heating Heating
HW a SW Heating and Service water (Domestic
hot water)
Position
Tank Integrated in the heat generator (=
heat pump or associated hydraulic
component)
Integrated Integrated directly in or on the heating
or hot water storage tank
– – – no ZWE 1 connected
Outlet The corresponding output contact
for electrical connection of the ZWE
is displayed automatically. If a type of
preparation is selected under “Type”
and it is displayed here as outlet “---““,
the wiring has already been laid in the
factory.
Second heat gen. 2 Selected additional heat generator 2
(ZWE 2)
Type
No no ZWE 2 connected
El.Rod Electric heating element with bivalent
level control for heating element ( not
released during the El. sup. blockade )
Function
No without function
Heating Heating
SW Service water (Domestic hot water)
If activated, no ZWE 1 used for
domestic hot water heating
Position
Tank Integrated directly in or on the heating
or hot water storage tank
– – – no ZWE 2 connected
Outlet The corresponding output contact
for electrical connection of the ZWE
is displayed automatically. If a type of
preparation is selected under “Type”
and it is displayed here as outlet “---““,
the wiring has already been laid in the
factory.