Controlling image capture
PIKE Technical Manual
V5.0.0
200
One-shot
The camera can record an image by setting the
one-shot bit
in the 61Ch reg-
ister. This bit is automatically cleared after the image is captured. If the cam-
era is placed in ISO_Enable mode (see Chapter
203), this flag is ignored.
If
one-shot mode
is combined with the external trigger, the
one-shot
com-
mand is used to arm it. The following screenshot shows the sequence of com-
mands needed to put the camera into this mode. It enables the camera to
grab exactly one image with an external trigger edge.
If there is no trigger impulse after the camera has been armed,
one-shot
can
be cancelled by clearing the bit.
Figure 106: One-shot control (SmartView)
#
Read = rd
Write = wr
Address
Value
Description
7
wr
F0F0061C
80000000
Do one-shot.
6
rd
F0F0061C
00000000
Read out one-shot register.
5
wr
F0F00830
82000000
Switch on external trigger mode 0.
4
rd
F0F00830
80000000
Check trigger status.
3
wr
F0F00614
00000000
Stop free-run.
2
rd
F0F00614
80000000
Check Iso_Enable mode (
free-run).
1
rd
F0F00614
00000000
This line is produced by SmartView.
Table 68: One-shot control: descriptions