60
Rapier Series Switch
C613-03020-00 REV K
Figure 30
shows a typical output. The status of the test will be shown in the
right-hand column. For further information on the meanings of the other
figures, see the “Test Facility” chapter of your switch’s Software Reference.
Figure 30: Example output from the
show
test
command for a Rapier switch with an
AT-AR061 ECPAC installed
If you are unsure about running the Test Facility, or have difficulty evaluating
the results then contact your authorised Allied Telesis distributor or reseller.
Board ID Bay Board Name Rev Serial number
--------------------------------------------------------------------------
--
Base 86 AT-RP24 Rapier 24 M2-1 46690596
NSM 4PIC 87 AT-AR040-00 NSM 4PIC M3-3 6845206
PIC 38 1 AT-AR023-00 PIC Sync M1-1 8618528
PAC 153 AR061 ECPAC P1-16 6844578
Duration Details
Interface State Result Type (minutes) Data( %OK )
Control
--------------------------------------------------------------------------
port1 no test - - - - - -
port2 no test - - - - - -
port3 no test - - - - - -
port4 no test - - - - - -
port5 no test - - - - - -
port6 no test - - - - - -
port7 no test - - - - - -
port8 no test - - - - - -
port9 no test - - - - - -
port10 no test - - - - - -
port11 no test - - - - - -
port12 no test - - - - - -
port13 no test - - - - - -
port14 no test - - - - - -
port15 no test - - - - - -
port16 no test - - - - - -
port17 no test - - - - - -
port18 no test - - - - - -
port19 no test - - - - - -
port20 no test - - - - - -
port21 no test - - - - - -
port22 no test - - - - - -
port23 no test - - - - - -
port24 no test - - - - - -
syn0 no test - - - - - -
asyn0 no test - - - - - -
enco0 testing wait 4 minutes DES < 1 good(100.0) -
.
enco1 testing wait 4 minutes STAC < 1 good(100.0) -
.
---------------------------------------------------------------------------
