Alliance Laundry Systems SSE007*A3000, Сервисная инструкция

Страница: 2 / 88

505039
1
© Copyright 1999, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without
the expressed written consent of the publisher.
Table of Contents
Section 1 – Safety Information .........................3
Locating an Authorized Servicer: ............................4
Section 2 – Introduction ....................................5
Customer Service .....................................................5
Nameplate Location .................................................5
Model Identification.................................................6
How Your Dryer Works...........................................7
Section 3 – Troubleshooting..............................9
1. Motor Does Not Run .........................................9
2. Unit Stops In Cycle; Quits After The
First Few Loads; Has A Burning Smell;
Cycles On Motor Thermal Protector ...............10
3. Motor Runs But Cylinder Does Not Turn ......11
4. Motor Does Not Stop ......................................11
5. Heating Assembly Does Not Heat
Or Burner Does Not Ignite ..............................12
6. Igniter Does Not Glow (Gas Supply Sufficient)
(Gas Models)....................................................13
7. Burner Ignites And Goes Out
Repeatedly (Gas Models).................................13
8. Igniter Glows But Burner
Does Not Ignite (Gas Models) .........................13
9. Heater Assembly Or Burner
Shuts Off Prematurely......................................14
10. Heater Assembly Or Burner Repeatedly
Cycles Off On Limit Thermostat .....................14
11. Heater Assembly Or Burner
Does Not Shut Off ...........................................15
12. Clothes Do Not Dry .........................................15
13. Clothes Are Too Hot When
Removed From Dryer ......................................16
14. Ignition Control Flashes ..................................16
Section 4 – Grounding .....................................19
15. Ground Wires From Terminal Block Or Power
Cord To Rear Bulkhead And From Rear
Bulkhead To Control Housing .........................19
16. Ground Wires From Power Cord To Rear
Bulkhead and From Rear Bulkhead To Control
Housing. Check Wall Receptacle Polarity.......20
17. Ground Wires From Dryer Base To Wire
Harness And To Ignition Control (Gas Models
With Silicon Nitrate Ignition System) .............21
18. Metered and Nonmetered Models – Ground
Wires From Control Cabinet To Timer
(Depending On Model) or Control Panel.........22
Section 5 – Service Procedures .......................23
19. Access Panel ....................................................23
20. Control Panel and Controls (Electromechanical
Metered and Nonmetered) ...............................24
21. Control Cabinet Front ......................................30
22. Control Panel Overlay .....................................35
23. Timer (Electromechanical
Nonmetered Models) .......................................35
24. Accumulator (Electromechanical
Metered Models)..............................................36
25. Electronic Control............................................37
26. Coin Drop ........................................................38
27. Card Reader .....................................................40
28. Cabinet Top (Upper Dryer) .............................41
Reversing Door Procedure.....................................42
29. Inner and Outer Door Panels and Door Pull....43
30. Door Strike ......................................................43
31. Door Seal .........................................................44
32. Front Panel and Panel Seal ..............................45
33. Door Switch .....................................................45
34. Door Catch.......................................................45
35. Lint Filter .........................................................47
36. Loading Door and Door Hinge ........................47
37. Door Hinge ......................................................48
38. Hold-down Clips and Locators........................48
39. Burner System Components (Gas Models) .....48
40. Burner Housing And Heat Shroud
(Gas Models)....................................................52
41. Limit Thermostat (Gas Models) ......................53
42. Heating Element (Electric Models) .................53
43. Thermostat And Heater....................................53
44. Air Duct ...........................................................54
45. Motor and Exhaust Assembly..........................55
46. Front Bulkhead Assembly ...............................58
47. Cylinder Belt....................................................60
48. Cylinder Assembly ..........................................61
49. Rear Seal..........................................................62
50. Cylinder Rollers...............................................64
51. Outlet Cover ....................................................64
52. Rear Bulkhead And Heater Duct .....................65
53. Terminal Block or Power Cord........................67
54. Cabinet and Base .............................................69
Section 6 – Adjustments ..................................71
55. Leveling Legs ..................................................71
56. Burner Flame (Gas Models) ............................72