Alliance Laundry Systems SSE007*A3000, Сервисная инструкция

Страница: 29 / 88

30
505039
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
21. CONTROL CABINET FRONT
a. Unlock control panel. See Figure 8A.
b. Pull top of control panel away from control
cabinet and lift up. See Figure 8B.
c. Remove control panel from control cabinet. See
Figure 8C.
d. Disconnect all wires to components. See
Figure 9.
e. Remove ground clip holding ground wire to
control panel. See Figure 9.
NOTE: Refer to appropriate wiring diagram when
reconnecting wires.
f. While supporting the access panel, remove the
access panel from both dryers by removing the
two screws from the bottom edge of each access
panel. See Figure 7.
g. Gently lower each access panel to disengage
panel locators from the bottom edge of each
access panel. See Figure 7.
h. Remove two screws holding bottom tabs on
front panel to lower dryer cabinet. See
Figures 16 through 19.
i. Swing bottom of front panel away from lower
dryer to disengage hold-down clips and locators
from control cabinet.
j. Disconnect wires from door switch. See
Figure 15.
NOTE: Refer to appropriate wiring diagram when
rewiring switch.
k. Remove two screws holding bottom tabs on
control cabinet to front flange of lower dryer
cabinet. See Figures 16 through 19.
l. Remove two screws and shoulder washers
holding the upper dryer base to the top side of
the control cabinet. See Figures 16 through 19.
m. Reach in through front opening of control
cabinet and remove two screws (per side)
holding the control cabinet front to the front
flange of the control cabinet wrapper. See
Figures 16 through 19.
n. METERED MODELS (Coin Drop and Coin
Slide) - Unlock and remove two coin drawers.
Reach in through coin drawer opening and
remove two screws (per side) holding control
cabinet to control cabinet wrapper. See
Figure 17.
o. Reach through control panel opening and
remove two screws holding the control cabinet
wrapper tabs to the control cabinet front tabs.
See Figures 16 through 19.
p. Carefully pull control cabinet front straight out
from between the upper and lower dryers. See
Figures 16 through 19.
Figure 15
DOOR
SWITCH
TABS
D240SE3A