53277
17
Section 4 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
11. FRONT PANEL AND PANEL SEAL
IMPORTANT: Do not move dryer unit when lower
front panel is not in place.
a. Remove two screws from bottom edge of front
panel.
b. On upper unit, swing bottom of panel away
from dryer to disengage hold-down clips from
slots in cabinet top.
c. On lower unit, swing bottom of panel away
from dryer to disengage guide lugs from control
cabinet.
d. Disconnect wires from door switch and
indicator light.
NOTE: Refer to appropriate wiring diagram when
reconnecting wires.
e. Remove front panel seal from flange around
inside of door opening.
NOTE: Be sure seal is properly positioned when
installing on front panel. Ribbed side of seal should
be against inside of front panel.
12. DOOR SWITCH
a. Remove front panel. Refer to Paragraph 11,
steps “a” through “c”.
b. Depress tabs on top and bottom of switch and
push out toward front of panel.
c. Disconnect wires from door switch. Refer to
NOTE: Refer to appropriate wiring diagram when
rewiring switch.)
Figure 11
D240S
To Test Door Switch:
1. Disconnect wires from door switch.
NOTE: Refer to appropriate wiring diagram
when rewiring switch.
2. Set meter to read Ohms and apply meter probes
on switch terminals with door closed. You
should get “zero” reading.
3. Open door. Meter should read “infinite.
